Check that the complete kit is present and prepare the V5 printed parts. While parts are printing, you can connect the board and install the software.

Check the complete kit

ItemQuantityCheck
Arduino UNO Q12 GB RAM
Expansion board1V1.1 assembled board
HD1910M servos15Keep them outside the frame until IDs are configured individually
Battery pack18.4 V, >3500 mAh, >3C, XH2.54
Charger18.4 V, DC5521
FastenersAbout 300Sort by size; this is the packing count, not the number used in assembly
10 × 15 × 3 mm bearings11Check positions against the assembly illustrations
16 × 22 × 4 mm bearings11Check positions against the assembly illustrations
3025 speakers28 Ω, 3 W
Audio/video module set1Camera, microphone, audio electronics, fill light and matching cables
VL53L5CX ToF18 × 8 ranging module

These quantities follow the official complete-kit packing list. The open hardware self-sourcing BOM serves a different purpose. Compare your delivery with its packing list and contact the seller if anything is missing.

Prepare the tools

  • A computer with Arduino App Lab, internet-connected Wi-Fi and a USB-C data cable.

  • Screwdrivers that match the screw heads, ID labels or a marker, and a stable work surface or calibration stand.

  • V5 printed parts and adhesive suitable for the actual materials when fitting soft pads.

Get the print models from MakerWorld

MakerWorld international profile · MakerWorld China profile

On the Luwu profile, select the model for the complete XGO-Duck audio/video configuration. Download its print project and follow the instructions on that model page.

  1. Open the downloaded 3MF as a project in Bambu Studio to keep plate layouts and material assignments.

  2. Check the actual printer, nozzle, plate and filament. Use the layer height, support and material guidance supplied with the chosen model.

  3. Select only the backpack shell matching the board revision. The complete kit uses a V1.1 expansion board; V1 and V1.1 are board revisions.

  4. Inspect each plate, assign materials, reslice and review the preview. A 3MF is an editable project, not ready-to-run G-code.

  5. Test-fit one servo seat and one bearing seat before printing the full set. Remove supports and burrs, identify left/right parts and keep cable passages clear.

PartPrinting check
Body, head and bracketsChoose the audio/video structure and the materials specified by the model
Mouth and foot padsUse the matching TPU material and settings
Backpack shellChoose the shell for V1 or V1.1; do not print both
Passive-wheel skating partsPrint the matching parts if you plan to use skating mode

For a replacement part, select it within the corresponding MakerWorld project and verify quantity and left/right orientation.

Completion check

  • The kit is checked, and each servo can be connected individually.

  • The correct V5 project, board shell, tools and printing schedule are ready.

Next: 02 · Connect the board and find its IP