0.3.6 supports phone portrait and landscape driving. View → Show all reveals the other tools; rotating the phone releases active joystick input. Before first remote motion, acknowledge the rear-cover reminder after checking the correct shell for your expansion board, then repeat the intended action.
Use the cockpit at http://<board-ip>/ for normal operation and the motion console at http://<board-ip>:9527/ for status and calibration. Start on a clear, level floor with a charged battery and completed calibration.
Power on and charge
Check the battery connector and cable routing, then switch on the robot. Wait for the App and status to become ready.
Use the battery for standing and walking. The supplied 2 A charger may not supply the peak current required for movement.
To charge, switch the robot off and use the specified 8.4 V charger and DC5521 connection. Keep it switched off while charging.
Move deliberately
| Control | Result |
|---|---|
| Default Pose | Moves to the calibrated reference pose; confirm the mechanism is aligned |
| Walk | Activates the walking policy; begin with a small forward command |
| Skate | Uses the skating gait and passive wheels; there is no powered wheel drive |
| Stop / centered movement control | Stops travel while the active policy can continue balancing |
| Torque off / unload | Releases the joints; support the robot because it can fall |
Releasing a movement control is different from unloading the joints. Use the explicit Torque off control when you need the servos released. Keep hands clear while a policy or preset action is active.
Choose the control source
The browser supports direct commands. When gamepad control is enabled, its continuous movement stream owns that input; web mode changes and Torque off remain available.
AI voice actions are direct named actions. The Enable Remote Motion option is for phone/cloud motion and is off by default. Switching it on alone does not arm or start the robot.
A directional command may first bring the robot into a standing state. Check the current pose and readiness before sending another command.
A picking or gesture preset is a fixed motion sequence. It does not add object detection or autonomous navigation.
Finish a session
Stop travel on level ground. Support the robot before unloading.
Switch off before charging, moving connectors or changing the mechanism.
If a joint strains, feedback disappears or the robot tips over, stop the action and inspect the cause before retrying.
Related instructions: Bluetooth gamepad · Forward distance limits · Troubleshooting.
Wiki