These specifications describe the complete audio/video kit. Software instructions refer to XGO Duck AI 0.3.6, with V5 printed parts and the V1.1 expansion board.
Hardware and features
| Item | Configuration |
|---|---|
| Controller / RAM | Arduino UNO Q / 2 GB |
| Control architecture | Linux host + STM32U585 MCU |
| Actuators and feedback | 15 serial bus servos; magnetic encoder feedback |
| Servo / torque | Feetech HD1910M / 12 kg·cm |
| Motion | Walking / skating; passive wheels, no powered wheel drive |
| Arm / screen | No robotic arm / no onboard screen |
| Programming | Python; the Arduino / STM32 firmware builds with the App |
| Camera | 2 MP 1080P camera; capture and browser-stream settings are described in the media chapter |
| Audio and lighting | Microphone, two 3025 speakers (8 Ω / 3 W), fill light |
| Ranging | VL53L5CX, 8 × 8 ToF |
| Battery | 8.4 V 18650 pack, capacity >3500 mAh, discharge rating >3C, XH2.54 connector |
| Charger | Matching 8.4 V lithium-battery charger, DC5521 (5.5 × 2.1 mm) |
| Shell and structure | Print the V5 audio/video parts; choose the backpack shell for your board revision and assign TPU parts separately |
| Runtime on battery | Depends on motion, audio/video load and battery condition; no single verified duration is specified for the complete kit |
Charging Switch the robot off before charging and leave it off throughout charging. Use the charger specified for the actual battery pack.
Camera sensor resolution and browser-stream resolution are different; see camera and audio settings. Check quantities and printing preparation in step 1.
Wiki