0.3.6 supports phone portrait and landscape driving. View → Show all reveals the other tools; rotating the phone releases active joystick input. Before first remote motion, acknowledge the rear-cover reminder after checking the correct shell for your expansion board, then repeat the intended action.

Use the cockpit at http://<board-ip>/ for normal operation and the motion console at http://<board-ip>:9527/ for status and calibration. Start on a clear, level floor with a charged battery and completed calibration.

Power on and charge

  • Check the battery connector and cable routing, then switch on the robot. Wait for the App and status to become ready.

  • Use the battery for standing and walking. The supplied 2 A charger may not supply the peak current required for movement.

  • To charge, switch the robot off and use the specified 8.4 V charger and DC5521 connection. Keep it switched off while charging.

Move deliberately

ControlResult
Default PoseMoves to the calibrated reference pose; confirm the mechanism is aligned
WalkActivates the walking policy; begin with a small forward command
SkateUses the skating gait and passive wheels; there is no powered wheel drive
Stop / centered movement controlStops travel while the active policy can continue balancing
Torque off / unloadReleases the joints; support the robot because it can fall

Releasing a movement control is different from unloading the joints. Use the explicit Torque off control when you need the servos released. Keep hands clear while a policy or preset action is active.

Choose the control source

  • The browser supports direct commands. When gamepad control is enabled, its continuous movement stream owns that input; web mode changes and Torque off remain available.

  • AI voice actions are direct named actions. The Enable Remote Motion option is for phone/cloud motion and is off by default. Switching it on alone does not arm or start the robot.

  • A directional command may first bring the robot into a standing state. Check the current pose and readiness before sending another command.

  • A picking or gesture preset is a fixed motion sequence. It does not add object detection or autonomous navigation.

Finish a session

  • Stop travel on level ground. Support the robot before unloading.

  • Switch off before charging, moving connectors or changing the mechanism.

  • If a joint strains, feedback disappears or the robot tips over, stop the action and inspect the cause before retrying.

Related instructions: Bluetooth gamepad · Forward distance limits · Troubleshooting.