The XGO App shows model-specific controls. These instructions follow the Chinese Rider guide; button labels and features depend on the connected robot and installed software.

Connect over Bluetooth

  1. Install XGO App using the official download page. Bluetooth control does not require Wi-Fi.
  2. Place Rider on a level, open surface, switch it on and wait for initialization.
  3. Enable Bluetooth and grant the app's Bluetooth / nearby-device permissions and location permission if requested. In the app, select Bluetooth Control.
  4. Select your own Rider in the device list. Names such as XGORider_6059 in screenshots are examples; select the name displayed by your device. The connected app opens Rider's motion-control screen.

If Rider is missing, verify power, permissions and proximity; disconnect any other phone already controlling it before searching again.

Drive and adjust posture

The left stick controls forward/backward travel and turning. The center vertical slider changes height; the lower-right slider adjusts Roll. Reset below the height slider resets the robot. Begin with small stick inputs, then try height and Roll. The motion panel provides six preset actions and performance mode; keep enough space around the robot. The RGB sliders control red, green and blue, each shown from 0–255. The settings panel includes the gyroscope switch and the connected device's name and version.

Calibrate the initial position

Use the adjustment icon beside the settings gear and read the calibration explanation. Support Rider, then choose Enter Calibration Mode. The servos release holding torque; they do not need to be removed. Place body and legs to match the Rider-specific side-view illustration on the calibration page, then choose Finish Calibration to save the current joint positions. Release the joints and leave clearance while the robot returns to standing. This replaces the saved initial positions; don't substitute a quadruped or Ranger pose.

Wi-Fi video streaming

Connect Rider and the phone or computer to the same network. On Rider, open Sample Programs → Video Streaming and press D; wait for the device to display its actual address. Open the complete address in a browser, including http:// and port :8080, or choose Wi-Fi Video Streaming in XGO App. If discovery fails, refresh or enter Rider's IP. Press and hold directional controls to move and release to stop. Height is a 0–100% slider, not a measurement in centimeters; the page also offers balance, reset and preset actions.

Press Rider's C button to exit streaming. The documented current image exits the streaming application after approximately five minutes; if the page disconnects, check the device screen and reopen streaming. The timeout may differ across versions. For gamepad setup and other controls see the shared control guide.